What causes the DStv waiting for communication from primary decoder error?
When the “waiting for communication from primary decoder” error message pops up on your screen, it can be a major cause of concern. It is also known as the E143-4 error and is associated with extra view connections. There are several reasons to get this error message, and knowing them is vital. It will make it easier to handle them.
The E143-4 error can come during your extra view installation, and it will make the entire system unresponsive while you use it. It can also come after your extra view installation, where it begins working and later stops. These are all causes of the “waiting for communication from primary decoder” error, and identifying one you are facing will inform your solution.
What triggers the “waiting for communication from primary decoder” error?
The problem could come after you complete your extraview installation if it hasn’t been activated by Multichoice. You have to communicate to multichoice after your setup to ensure they send you the right signal. If it was working before, the “waiting for communication from primary decoder” error could come when you delay your subscription.
It can also get triggered if your primary decoder is not sending enough signals to the secondary decoder. This is usually a problem with the connection or a poor signal from the satellite dish due to installation problems.
How to correct the “waiting for communication from primary decoder” error
First, ensure your connection is approved by Multichoice. Inform them of all the secondary decoders in your setup to ensure you get a strong signal. They will activate your setup after some time, and it will get rid of the “waiting for communication from primary decoder” error. You should also ensure your subscription is up to date.
You can also solve the “waiting for communication from primary decoder” error by correcting your installation. Ensure your satellite has the right elevation and is facing the right direction so that your decoders get a strong signal. You can also look into the state of your heartbeat cable as it could be the cause of your “waiting for communication from primary decoder” error.
Purchase new cables or repair those you have for the best connection. These are the causes of the “waiting for communication from primary decoder” error and how you can fix them yourself.
https://en.wikipedia.org/wiki/DStv
https://www.lemmymorgan.com/fix-xtraview-e143-0-error/
The post Waiting for communication from primary Decoder appeared first on Dstv Installer Johannesburg - 063 872 7325.
source https://imveloawards.co.za/waiting-for-communication-from-primary-decoder/
No comments:
Post a Comment